DISCO DAD 2H/6T, Руководство по устранению неисправностей

Страница: 113 / 186

E-30
DISPLAY SIGNIF SOLUTION
E A006
E A007
E A008
E A009
E A010
E A011
E A012
IN FULL AUTO, 90° ROTATION FOR ALIGNMENT OF THE SECOND CHANNEL
INOPERABLE
The 3 operations below have not been completed, preventing the unit from proceeding
with alignment of the second channel.
Make sure these operations are performed fully, then press the or the keys.
(1) Spindle is operating (LED is on)
(2) Vacuum is operating (LED is on)
(3) Final adjustments of the Y- and
θ
-axes have been made.
(Alignment must end with the operation of and keys)
IN FULL AUTO, START/STOP KEY WILL NOT START CUTTING OPERATION
The 3 operations below have not been completed, preventing the start of automatic
cutting. Check that all three are done and then press START/STOP key.
(1) Spindle is operating (LED is on)
(2) Vacuum is operating (LED is on)
(3) The second channel fine adjustments of the Y-and
θ
-axes have been
completed.
(These must end with the operation of
for the Y-axis and for the
θ
-axis)
AFTER OPERATOR STOPS FULL AUTO FOR CHECK, START/STOP KEY
INOPERATIVE
If the chuck table has been moved during the FULL AUTO stop, the movement must
end with the operation of and/or to enable the START/STOP button to be
effective. Press these and then recontinue FULL AUTO cutting.
SPINDLE or VACUUM OFF KEYS PRESSED DURING FULL AUTO,
INOPERATIVE
For safety reasons, neither spindle nor vacuum can be turned off during FULL AUTO
cutting. The keys can be operated when cutting sequence has been completed.
Z-AXIS JOG KEY PRESSED, INOPERATIVE
Until SET-UP operation has been completed, Z-axis JOG key is ineffective.
Complete set-up and press again.
θ
-AXIS JOG/SCAN OPERATIONS CANNOT BE INITIATED
The
θ
-axis cannot operate because it is more than ±10° away from the zero point.
θ
-AXIS DOES NOT ROTATE
The rotation process cannot be performed more than twice in the same direction
during manual operation.
850130