ASSEMBLY: CONTINUED
HOW TO OPERATE
ATTACH TOOLS:
(A) - Slide the dust
brush onto the post on the tool caddy
with bristles facing out. Push down to
secure. (B) - Slide the extension wand into
the round slot on the right. (C) - Slide the
crevice tool into the round slot on the left.
9.
A
B
C
TOOL STORAGE
Push back dirt window flap. Align tabs
on clear dirt passage window with the
slots on the lower hose cuff. Push and
turn to lock into place (inset).
Place the hose into the
two side hose clips.
7.
8.
7
To release your cord, turn the
top cord hook to the left or
right.
Keep the cord out of the way
while you vacuum by snapping
it into the cord guide on the
back of the handle.
Plug cord into electrical outlet.
Step on the power switch to turn
on the cleaner. Switch is grey
and located on the base of the
unit.
1.
2.
3.
QUICK CORD RELEASE
WARNING:
FULLY ASSEMBLE CLEANER BEFORE OPERATING.
NOTE:
Paper bag must be properly installed before operating.
CORD GUIDE
ON/OFF SWITCH
Release the handle. With your
foot,
depress the handle
release pedal on the left side
of the base.
Move the handle and adjust it to the
desired position for (A) storing the
upright, (B) operating the cleaner, and (C)
low profile for cleaning under furniture.
NOTE:
You will need to depress handle
release pedal again for low profile.
Cleaner must be locked in the
upright position to lift the
rotating brush off the carpet
when cleaning above the floor.
Turn cleaner off
BEFORE
attaching or removing hose.
1.
2.
FLOOR/CARPET CLEANING
A
B
C
1.
ABOVE FLOOR CLEANING
8
Take front panel off by
squeezing front panel release
lever towards you.
Grasp cardboard collar of paper bag
with both hands and pull past raised
locking tabs on the dirt tube.
Dispose of old paper bag.
IMPORTANT:
EXTEND BAG AWAY
FROM HOLE BEFORE INSTALLING.
Press in opening to clear paper
away from hole.
1.
2.
3.
TO REMOVE
NOTE:
Unplug cleaner before changing paper bag. Cleaner must have paper bag in place at all times.
Push cardboard collar past raised locking tabs on the dirt tube
with both hands (Diagram 1). The bottom of the bag should be
resting on the posts located inside the right and left of the bag
chamber (Diagram 1a). Be sure paper bag is fully extended
and tucked in at the top and bottom (Diagram 1b).
Replace front panel by putting the one bottom
tab in the slot on the vacuum (Diagram 2). Close
until it snaps into place (Diagram 2a).
2.
U
BAG TYPE
Lift up on front edge
and pull towards you to
remove. Brush or
shake filter debris until
dirt stops falling from
the filter. In some
cases, more or less
cleaning of the filter
may be required.
2.
1.
Take front panel off
by squeezing front
panel release lever
towards you.
WARNING:
UNPLUG CLEANER BEFORE CHANGING FILTER.
BAG CHAMBER FILTER (INTERNAL)
Located under the paper bag.
Raised Locking Tab
Hole
2a.
Tab
Slot
TO INSTALL
1.
Raised
Locking Tab
1a.
1b.
PAPER BAG: REMOVAL & REPLACEMENT
FILTER PAD CLEANING INSTRUCTIONS
For Bag Type U replacements, please visit our website at www.dirtdevil.com to buy
online or call customer service at 1-800-321-1134.
