13
GB
4 Use
4
Use
4.1
Operational safety
4.2
Vacuum cleaning
1.
Pull out the cord by the plug up to the yellow mark (Fig. 5/1).
2.
Insert the mains plug into a socket with ground/safety contact.
3.
Switch on the cylinder vacuum cleaner with the on/off switch (Fig. 5/5).
4.
Set the suction power at the suction power control (Fig. 5/4) to suit the
type of floor to be cleaned.
5.
If using the floor nozzle, set the ‘carpet/hard floor’ selector according to
the type of floor to be cleaned (Fig. 6/1):
- Fig. 6/A: for deep- and short-pile carpets, runners
- Fig. 6/B: for smooth floors, e.g. parquet, tiles, PVC, etc.
4.3
Switching off
1.
Switch off the cylinder vacuum cleaner with the on/off switch (Fig. 5/5)
and pull the plug from the mains socket.
2.
Keep the plug in your hand.
3.
To retract the power cord, push the cord retraction button (Fig. 5/3).
4.4
Transport and storage
Only carry the cylinder vacuum cleaner by its carrying-handle (Fig. 7/
B1).
For storage you may either park the telescopic tube using
- the parking-hook of the floor nozzle (Fig. 7/A) or
- the storage-hook (Fig. 7/B).
If you want to store the appliance for a longer period of time, remove
the dust filter bag (
Z
Chapter 5.1, “Changing the dust filter bag”
).
Store the appliance in a cool, dry place, out of the reach of children.
WARNING:
Danger of injury! Check appliance and power cord before each use. A
damaged appliance must never be used.
WARNING:
Danger of injury! Especially when vacuum-cleaning stairs make sure
that you always stand on a higher level than the appliance.
ATTENTION:
Only use the cylinder vacuum cleaner when all filters are intact, dry and
correctly fitted. Make sure that no objects obstruct the telescopic tube,
the suction hose or other openings.
NOTE:
Your cylinder vacuum cleaner is equipped with a safety switch to prevent
overheating. It will switch off automatically if overheated (e.g. due to
clogged suction channels).
If this happens:
Switch off the vacuum cleaner.
Pull the plug out of the plug socket.
Eliminate the cause of the overheating.
Wait for about 45 minutes.
After it has cooled off, you may switch on the vacuum cleaner again.
3
2
1
5
4
6
5
B
A
1
6
WARNING:
Danger of electric shock! If the red marking (Fig. 5/2) shows, press the
cord retraction button (Fig. 5/3) to pull in the cord up to the yellow mark
again (Fig. 5/1). Otherwise, the power cord may be damaged.
NOTE:
The bypass vent (Fig. 5/6) should normally be completely shut so that
the suction power is not reduced unnecessarily. With the bypass vent
you can quickly reduce the suction power to release items e.g. curtains
that have accidentally been sucked in.
WARNING:
Danger of injury! When leaving your working-area, switch off the appli-
ance and comply with the notices in
Z
Chapter 4.3, “Switching off”
. This
will help avoid accidents.
WARNING:
Danger of injury! During uncontrolled retraction the power cord can whip
around, become a tripping hazard or knock over objects. Therefore,
keep the plug in your hand and guide the cord when retracting it.
A
B
1
7
ATTENTION:
Never store the appliance next to heat sources (e.g. stoves or radiators).
Avoid exposing it to direct sunlight. Heat can damage the appliance.
M7123.book Seite 13 Dienstag, 9. Oktober 2012 9:37 09
