Directed Install Essentials CAN1, Руководство по установке, Страница: 12 / 23

12
© 2005
Directed Electronics, Inc.
N3/2 WHITE/BLACK (-) rear windows down input
Connect this wire to a channel output of the security system. Configure the output type as
“validity”.
N NO OTTEE:: This input is only valid with the ignition OFF.
➤ ➤
If a short pulse (less than 1-second) is received on this input, if CAN-IM finds any of the rear
windows above the “small vent” position, it will roll down the rear window(s) at the “small vent”
position, else if it finds any of the rear windows above the “large vent” position, it will roll down the
rear window(s) at the “large vent” position. In any other case the input will be ignored. In no case
will the windows be rolled up.
➤ ➤
If a long pulse (greater than 1-second) is received on this input, CAN-IM will roll down the rear
window(s) as long as the input remains active.
➤ ➤
This input is not valid during the execution of the comfort closure function after an arm/lock
command.
N3/3 VIOLET/BLACK (-) no connection
This input m muusstt not be connected. The function is not available.
N3/4 BROWN (-) headlight input
Connect this wire to the security system channel output required for headlight activation feature
or to the “(+/-) Light/Flash” wire of the remote start module. Configure this as a negative output
from that system.
N3/5 GRAY/BLACK (-) fuel door release input
Connect this wire to a channel output of the security system. Configure the output type as “validity”
or “timed” (1-second is enough).
N3/6 ORANGE/BLACK (-) radio input
Connect this wire to “retained accessory output” of the security system. Or connect to a channel
output of the security system. Configure the security system channel output type as “latched”.
N NO OTTEE:: If the ignition is ON or the key is still in the ignition switch after ignition OFF, this input will be
ignored.
➤ ➤
This function will only be effective if the radio is left ON when the ignition is turned OFF and the
key is taken out from the ignition switch.
➤ ➤
If the car is nnoott eeq
quuiip pp peed d with a radio it is strongly recommended that this input not be
connected as it will discharge the vehicle’s battery (especially for Seat, and some Skodas, and VW’s).
➤ ➤
As long as this input is active and effective the original factory remote control of the vehicle is not
functional because the messages broadcasted on the bus will simulate that the ignition is ON or the
key is still in the ignition switch after the ignition is OFF. This is the natural behavior of the vehicle.