Dion-Ag F64-90R, Руководство оператора

Страница: 30 / 38

ADJUSTMENTS
30
DISK CLEANER ADJUSTMENT
FIGURE 43
To prevent debris accumulation and material jam,
regularly check and adjust the disk cleaning forks
located on the lateral fingers. Adjust so that the gap
between the tip of the teeth and the cleaner is kept at
1/4” (6 mm) or less but without ever touching the disk.
Figure 43 Disk cleaners
KNIFE SECTION REPLACEMENT
FIGURES 44 AND 45
Each knife is made of 4 sections. Each section can be
replaced individually. These sections are made from
tempered steel for extended life. In case of failure or
premature wear, they can be replaced as described
below.
1. Remove the four bolts holding the knife section.
2. Remove the reinforcement plates under the disk.
3. Replace the section then install the reinforcement
plates back under the disk with the four bolts
supplied with the knife.
4. Tighten all bolts back.
1
Figure 44 Removing the four bolts
Figure 45 Replacing a knife section
DEFLECTOR-KNIFE REPLACEMENT
FIGURE 46
The deflector-knives are installed under the disks
(around the edge or on the spokes) to prevent debris
built-up on the machine frame. These deflector-knives
must be replaced if they are broken or worn out. It is
important to follow the deflector-knife configuration in
order to maintain the machine’s good working order and
to keep the saw balanced.
1
1
Figure 46 The deflector-knives
Manual No.F6418E996E