DINGLI BA14J-AWD, Руководство по эксплуатации и обслуживанию

Страница: 78 / 97

Operation & Maintenance Manual Section7-General Maintenance
Dingli Machinery
7-7
Replace the Suction Filter Procedure:
1) Clean the area around the two suction ports, which is located in the lower-left corner
of the hydraulic oil reservoir, disconnect the hose from the fittings.
2) Use a wrench to loose and remove the 6 bolts from the hydraulic oil reservoir, pull the
flange away from the reservoir, then turn the filter element from the adaptor, and
check the O ring on the adaptor, replace if necessary.
3) Take a new filter element to screw it onto the filter adaptor.
4) Install the adaptor in the reservoir, and be careful with the filter and O ring, then
tighten it with the six bolts.
5) Connect the hose adaptor to the fitting with correct torque. Clean up any oil that may
have spilled during the replacement procedure.
6) Repeat step 1) to step 5 with another circuit suction port II the new filter element to
the filter assembly chamber.
7) The suction filter element Dingli Part Number is WU-63*80-J
8) Interval—Every 2years or 1200 hours of operation. Remove and clean at time of
hydraulic oil change.
7.4.5 Replace the Engine Oil
Refer to the Engine Operation and Maintenance Manual for detail information.
7.4.6 Replace the Engine Fuel Filter
Replacing the diesel fuel filter is essential to good engine performance and service life. A
dirty or clogged filter may cause the engine to perform poorly and continued use may
cause component damage. Extremely dirty conditions may requires that the filer be
replaced more often. Refer to the Engine Operation and Maintenance Manual for detail
information