digmoda DDC520, Руководство пользователя

Страница: 3 / 28


  

Your DDC 500 Series Amplifier is factory programmed to 0dB Output Gain; please take your precautions
before applying any audio signal to the input.

Read the Amplifier specifications (page 22) before connecting loudspeaker loads.

Do not operate the LF, MF and/or HF amplifier sections (depending on the model) to Max Power when all the
channels are set to flat response without crossover filters. Such settings will force the amplifiers with lower
power rating to exceed the maximum output and may result in failure.

Do not run unfiltered high frequency test signals (5-20 kHz) for more than a few seconds since this could cause
permanent damage to the Amplifier.

Make sure to run the amplifier with all channels connected to a load.

Always turn off the unit when not in use.
Operation
KSC Industries cannot be held responsible for damage caused by improper use or modifications to the amplifier system.
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
BACK COVER.
The exclamation point within the equilateral triangle is intended to alert the user to the presence of
important operating instructions in the literature of the product.
The lightning flash with arrowhead symbol, within the equilateral triangle, is intended to alert the user to
the presence of un-insulated “dangerous voltage” within the product’s enclosure that may be of
sufficient magnitude to constitute a risk of electrical shock.
FCC Information (U.S.A.)
This device complies with Part 15 of the FCC rules. Operation is subject to the
following conditions: (1) This device may not cause harmful interference, and (2) This
device must accept any interference received, including interference that may cause
undesired operation.