D-FORCE600VA SLIDING GATE OPERATOR
D-FORCE600VA: AC220V
D-FORCE600VA U: AC110V
c.
Output power supply: 12VDC(7 of J5), COM (9 of J5), I.R. (8
of J5 is N.C Infrared)
If the infrared beam is interrupted during closing, the gate will reverse and
open immediately. The product is not factory equipped with an infrared
device; the infrared output signal must be N.C.
From four-terminal
to the receiver
COM
OUT
RX Receiver connecting
JUMP
NC OR NO
NC
NO
Form two-terminal to the emitter
12--24V AC/ DC
TX Emitter connecting
power supply
7
9
8
Control board
Terminal J5
Fig.9 infrared
Schematic diagram
d.
Three-button switch / single-button switch (keypad): The D-
FORCE600VA is equipped with interfaces for three-button switch and
single-button switch (keypad).
To install the keypad attach one lead of your keypad to ‘5’ of terminal
J2 and the other to the ‘4(COM)’. The keypad will function in single
channel mode.
For three-button switch installation, use the terminals for multi-
channel mode. Connect open wire of external button switch to ‘1
(CLOSE)’ of terminal J2, connect close wire of switch to ‘2 (OPEN)’,
connect stop wire of switch to ‘3(STOP)’, connect common wire of
13
