D-FORCE600VA SLIDING GATE OPERATOR
Fig.4
5. Adjustment
Spring limit switch
To ensure safety, it is recommended to install limit switches at both
ends of the gate to prevent the gate from sliding out of the rails. The
rails must be installed horizontally.
Install the limit block as shown in Fig.5 and Fig.6. The spring limit
switch and blocks are used to control the position of the gate.
Release the gear with the key and push the sliding gate manually to
pre-determine the position, fix the block to the rack and lock the gear
by push up the release bar. Moving the gate electrically, adjust the
block to the proper position until the position of the opening and
closing meet the requirement.
Magnetic limit switch
To ensure safety, it is recommended to install limit switches at both
ends of the gate to prevent the gate from sliding out of the rails. The
rails must be installed horizontally.
Install the limit block as shown in Fig.5 and Fig.6. The magnetic of
limit switch and blocks are used to control the position of the gate.
8
