D-FORCE1400VA SLIDING GATE OPERATOR
button 2 too, the button 2 and button 4 are enable, the button 1 is
disable.
Button 1
Button 2
Button 3
Button 4
Fig.12 Remote transmitter
Adding extra remote controls
(Learn):
Remove the cover, press and
hold the learn button ‘S1’ (Fig.8) more than 2 seconds, then the ‘LED
of LEARN’ (Fig.8) will be on, then press the remote control button
which you want to use, the ‘LED’ will turn on about 2 seconds and
then turn off again. The learning process is finished. Up to 25 remote
controls may be used.
Erase remote controls: To erase all existing remote controls, press
and hold learn button ‘S1’, the LED of ‘LEARN’ will turns on,
release the button until the LED turns off. This indicates that all the
remote controls have been erased completely.
Verify
open direction: If the gate does not move in the desired
direction, then you will need to reverse the motor operating direction,
open the black plastic cover, you can do this by exchanging wires
‘MOT1’ and ‘MOT2’, ‘Open limit(13 of J5)’ and ‘Close limit(11 of
J5)’.
16
