Digital Projection
M-Vision Cine 320 3D Series
A TOUR OF THE MENUS
Operating Guide
38
Rev E July 2014
Advanced Image menu continued from previous page
Fine Sync
•
V Position
and
H Position
Set the sliders as required.
•
Phase
Adjusts the phase of the pixel sampling clock relative to the incoming
signal. Adjust the phase if noise is visible.
•
Tracking
Adjusts the frequency of the pixel sampling clock. Flicker or vertical
banding indicate poor tracking.
•
Sync Level
Adjusts the voltage level of the signal detection circuitry. Adjust if the
projector loses sync during scenes where the signal drops below black.
Highlight the Fine Sync setting, and then either press
ENTER/SELECT
to
access it, or use the
LEFT
and
RIGHT
arrow buttons to switch between
values.
Press
MENU
to go back.
Color Mode
This setting adjusts the lamp driver waveform and color wheel programming
according to the image requirements of the user. Use the
LEFT
and
RIGHT
arrow buttons to select from:
•
Mode 1
•
Mode 2
Notes
Some of the settings within the
Fine
Sync
sub-menu,
Phase
,
Tracking
and
Sync Level
, affect only RGB
and Component input sources.
These settings are not available
if the projector is using a different
source.
Adjust the
Phase
after adjusting
Tracking
.
H Position
ADVANCED IMAGE >> Fine Sync
V Position
100
100
Phase
100
Tracking
100
Sync Level
100
