Digital Projection
M-Vision Cine 320 3D Series
A TOUR OF THE MENUS
Operating Guide
33
Rev E July 2014
Main menu continued from previous page
Overscan
This setting, if switched on, removes unwanted artefacts from the edges of
your image by cropping the edges or increasing the size of the image to force
the edges off-screen.
Unwanted artefacts along the image edges usually occur when the projector
is connected to a low quality input souce.
Choose from
Off
,
Crop
or
Zoom
.
3D Control
Use this sub-menu to enable, disable and set up 3D input, as follows:
•
Enable 3D
—
On
and
Off
•
3D Format
—
Auto
(recommended),
Side by Side
,
Top and Bottom
,
Dual Pipe
•
DLP Link
—
On
(if you are using 3D glasses that can utilise the DLP
Link® signal embedded in the image) and
Off
•
3D Swap
—
Normal
and
Reverse
(set to
Reverse
if the 3D images are
displayed in the wrong order)
•
Dark Time
—
1ms
,
1.5ms
,
2ms
and
2.5ms
. Set to reduce the effect of
images overlapping whilst the glasses are switching
•
Sync Delay
— use the
LEFT
and
RIGHT
arrow buttons to set the
value in milliseconds, to compensate for signal processsing delays in the
projector.
•
1080p24 3D Display
— if you set this to
144Hz
, 30 lines are cropped
from the top and bottom of the frame;
96 Hz
displays the full frame.
L
R
L
R
Side by Side
Top and Bottom
Dual Pipe
HDMI 1
HDMI 2
L
R
Notes
For a list of supported 3D formats,
see the
Connection Guide
.
3D video is only possible on the
HDMI inputs.
Most of the
3D Control
settings,
including
Enable 3D
, will be
unavailable if
3D Format
is set
to
Auto
and
the projector is not
receiving a 3D image from the
source. To activate the
Enable
3D
setting, change
3D Format
to
something other than
Auto
.
If
Enable 3D
is available but set to
Off
and you decide to change the
value of the
3D Forma
t setting, your
action will switch
Enable 3D
on.
The
Frame Packing
format is
automatically detected by the
projector.
