Digital Projection M-Vision 930 3D Series, Инструкция по установке и быстрому запуску

Страница: 19 / 140

page 11
Digital Projection M-Vision 930 Series
Installation and Quick-Start Guide
POSITIONING THE SCREEN AND PROJECTOR
Rev C February 2015
Positioning The Screen And Projector
1. Install the screen, ensuring that it is in the best position for viewing by your audience.
2. Mount the projector, ensuring that it is at a suitable distance from the screen for the image to fill the screen. Set the adjustable feet so that
the projector is level, and perpendicular to the screen.
The drawing below shows the positions of the feet for table mounting, and the fixing holes for ceiling mounting.
1 Four adjustable feet
2 Six M6 holes for ceiling mount
The screws should not penetrate more than 15 mm into the body of the projector.
Notes
Always allow the projector
to cool for 5 minutes before
disconnecting the power or
moving the projector.
Ensure that there is at least 30
cm (12 in) of space between the
ventilation outlets and any wall,
and 10 cm (4 in) on all other
sides.
Do not stack more than 3
projectors.
Do not tilt the projector more than
±12° from side to side when in
use, as this may cause system
failure.
±12°
360°
1
2
1
1
1
2
2
2
2
2