Digital Equipment HiNote VP 700 Series, Справочное руководство по обслуживанию, Страница: 57 / 149

System Restoration
2-16
4. At the DOS prompt type: PHDISK /create 151552. This
will create a 148MB non-DOS partition to be used for
Save-to-Disk operations. Note that there must be a
space between “PHDISK “ and “/create” and a space
between “/create” and “151552”.
5. Remove the DIGITAL HiNote VP 700 System CD and
place the Windows NT 4.0 CD into the CD-ROM drive,
then reboot the system.
6. Follow the on-screen instructions ensuring that when
prompted to choose the file structure that you specify
NTFS.
7. When Setup is complete, remove the Windows NT CD
and insert the DIGITAL HiNote VP 700 System CD.
Click on Start then Run and type X:\CDInstall, where X
is drive letter assigned to the CD-ROM drive. Follow the
on-screen instructions to install the desired applications,
interactive User documentation and all system drivers.
Creating a Save-to-File (FAT16 Only—Non NTFS)
Shipped from the factory, your system has approximately an
84MB Save-to-File.bin file which enables you to use your
notebook’s Save-to-Disk feature. If you increase the RAM over
80MB total or complete the Windows NT 4.0 System Restoration
process, you need to create a DOS Save-to-File.bin file which
matches the amount of RAM installed.
To create the Save-to-File.bin file, please refer to the following:
1. Run ScanDisk to ensure there are no disk errors. Then
defrag your hard drive to ensure you have enough
contiguous free space to create the Save-to-File.bin file.
2. Insert the DIGITAL HiNote VP 700 Series System CD
into the CD-ROM drive and boot the system.