Digital Equipment EtherWORKS Turbo PCI, Информация пользователя

Страница: 38 / 48

Table A–2 (Cont.) Diagnostic Test Error Codes
Error Message Recommended Actions
Err 32, TDES0: chained xmt/rcv test error
Err 33, Internal loopback test error
Err 34, 10Base-T internal loopback test error These messages indicate
an IRQ conflict (when two
boards want to use same
interrupt line). Reconfigure
board to use another IRQ
line. If problem persists,
board could be defective.
Contact Digital Technical
Support.
Err 35, 10Base-T external loopback test error
Err 36, AUI external loopback test error Improper termination
causing Loopback test to
fail. Supplemental network
tests require loopback
connectors for ThinWire
or TP repeater link for TP
testing (available when
diagnostics are run from
NICDIAG diagnostic menu).
To test ThinWire coaxial
port, remove board from
live network, terminate
T-connector. To test TP port,
board must have valid link
to TP repeater (green LED
lights when good link). If
LED does not light, check
TP cabling and TP repeater
port.
To test AUI port, select
AUI port using board AUI
jumper and connect to AUI
Hub or repeater. If error
persists, board could be
defective. Contact Digital
Technical Support.
(continued on next page)
A–6