Digital Equipment DECserver 700-08, Руководство владельца оборудования, Страница: 69 / 77

7–5 What to Do If You Have Problems
7.5.1 Error Message 952
Local –952– Enter ^P to repeat self-test
Problem
An error was detected on the Ethernet port.
Correction: The DECserver 700 displays this error message with error message
941. Refer to Section 7.5.3 for the correct action.
7.5.2 Error Message 922
Local –922– Port hardware error on port n
Problem
The specified port has failed self-test.
Correction: There is no corrective procedure for this condition. Notify the network
manager that the DECserver 700 must be returned to Digital Equipment Corporation
for repair or for replacement. Refer to the Network Access Server Problem Solving
manual for information about returning the unit to Digital Equipment Corporation.
7.5.3 Error Message 941
Local –941– Transceiver loopback error
Problem
The Ethernet port has failed self-test.
Correction: Standard Ethernet/ ThinWire Ethernet – Disconnect the cables or MAU
from the standard Ethernet connector and insert a loopback connector part number
12-22196-02. Test the hardware again by pulling out the power cord and reinserting
it. If this corrects the problem, the fault is external to the DECserver 700. If this fails
to correct the problem, notify the network manager that the DECserver 700 must be
returned to Digital Equipment Corporation for repair or for replacement. Refer to the
Network Access Server Problem Solving manual for information about returning the
unit to Digital Equipment Corporation. If the DECserver 700 passes self-test, then
the problem lies in the cables or equipment connected to the DECserver 700.