Digital Equipment DECserver 700-08, Руководство владельца оборудования

Страница: 50 / 77

5–2 Site Preparation and Maintenance
8. Remove the anti-static kit.
9. Replace the cover (Figure 5–8).
10. Connect a terminal to the DECserver 700 (Section 7.5).
11. Reconnect the cables and test the DECserver 700 (refer to the DECserver 700
Hardware Installation Card).
NOTE
If the SIM memory is faulty, the DECserver 700 flashes
“C” if the faulty SIM is in connector 1 and “d” if the
faulty SIM is in connector 2. If you install the wrong
type SIM, the DECserver 700 flashes “n”. Remove or
replace the SIM to repair the DECserver 700.
12. Check status message 960 to verify memory size:
Local –960– Available memory 4 Mbytes
5.2 Additional Memory Supported
You can increase the memory of your DECserver 700 by adding extra single-in-line
memory modules (SIMs). The DECserver 700 contains 4 Mbytes of SIM memory.
However, future releases of DECserver 700 software may contain additional func-
tions that require more SIM memory. You can install the additional SIM memory on
site. Adding an additional 1 Mbyte will increase the memory to 5 Mbytes and adding
an additional 4 Mbytes SIM will increase the memory to the maximum of 8 Mbytes.
The DECserver 700 supports:
•
1 Mbyte SIMs (256K x 36) DEC Part No 20-35191-05,
Order Number MS40-WA
•
4 Mbytes SIMs (1M x 36) DEC Part No 20-37656-05,
Order Number MS40-WB
There are two SIM connectors on the DECserver 700 printed circuit board. One of
the connectors contains the factory installed 4 Mbytes SIM (Figure 5–4).