Digital Equipment DECserver 700-08, Руководство владельца оборудования

Страница: 62 / 77

6–2 Site Preparation and Maintenance
6. Insert the replacement or Flash RAM Card update in the connector
(Figure 6-2).
NOTE
The Flash RAM socket is keyed. Ensure that you follow
the instructions located on the Flash RAM card when
installing.
7. Remove the anti-static kit.
8. Replace the cover (Figure 5–8).
9. Connect a terminal to the DECserver 700 (Section 7.5).
10. Reconnect the cables and test the DECserver 700 (refer to the DECserver 700
Hardware Installation Card).
11. Check the status of the Flash RAM card by using the SHOW MEMORY
CONFIGURATION command.
Example
Local> SHOW MEMORY CONFIGURATION
Dynamic RAM: 4M bytes
Non-Volatile RAM: 32K bytes
Flash RAM:
Installed:
Yes
Total size: 4M bytes
Boot block: Valid
Load image:
Name:
WWENG1
Size: 967756 bytes
Version: DECserver 700-16 V1.0 BL34A-2C
NOTE
If Flash RAM is installed, but its boot block is invalid,
then the total memory size will be displayed as zero.
Your Flash RAM can also be updated with the INITIALIZE command. This command
copies the load image to Flash RAM. For more information about the SHOW MEMORY
CONFIGURATION or the INITIALIZE command, refer to the Network Access Server
Management or Network Access Server Commands manual.