DIGITAL DELAY Mega 475, Инструкция по эксплуатации

Страница: 29 / 66

- 29 -
Note: The Mega 475 updates the Tap and How Late
information each pass. So there is no need to manually clear
the Tap Count and How Late.
If you want to manually clear the Tap Count and
How Late information, the Selection Arrows need to be on
the second line, and then press the CLEAR key.
Push-button Mode and Interrupt Time
There are 5 different Push-button Modes listed
below, including Set and Go which sets the Transbrake on
the press of button and starts the counting down on the press
of a second button. Each button mode changes how the
Mega 475 handles the input from the push-buttons to activate
the Transbrake, allowing the driver to select the preferred
method.
1)
PB Mode 1 – one hit at the tree with one button:
Use this mode if you only planning on taking one
hit at the tree. This is the most commonly used
mode.
2)
PB Mode 2 – two hits at the tree with two
buttons: Use this mode if you want to take two
hits at the tree with two separate buttons.
3)
PB Mode 3 – two hits at the tree with one button:
Use this mode if you want to take two hits at the
tree with one button.
4)
PB Mode 4 – two hits at the tree with one button:
Use this mode if you flinch a lot at the starting
line. In this mode you can cancel the first hit
because of a potential red light due to a flinch and
switch to a second hit.
5)
PB Mode 5 – Set and Go: Use this mode if you
want the start the delay timing on the press of the
button instead of the release. One hit at the tree
using two buttons. Explained further on page 31.