Digifly VI100, Руководство пользователя

Страница: 22 / 32

- the recording sample frequency, if the logger is on, return to the pre-set value by
setup.
- the multifunction display retunr to show the instrument active before entring in
“NEAR” zone, giving back available all 6 possible indications.
Step 5 - END
Vl100 waits until 1000 meters away from waypoint centre before accept from the
GPS a new waypoint (see Step 1).
This navigation mode tells the pilot themoment he crosses the start gate. The
management of this kind of navigation is subdivided as follows:
Make sure that VL100 doesn’t have any waypoint kept in memory (waypoint name
memory= “NOWP”) , on the contrary it must be cancelled (see waypoint
cancellation)
When VL100 receives from the GPS a GOTO for a waypoint (in GOTO or ROUTE
mode) in order for the VL100 to recognise the waypoint as a start pylon the
following conditions must occur:
Multifunction display navigation in the FAI sector
4.2 STart Pylon Navigation (SPMO different to 0)
Step 1 - NO WAYPOINT ON
Step 2 - WAYPOINT aquisition START PYLON
· SPMO different to 0
· pilot must not be in flight (Ground Speed < 5 km/h and Vario b/-
0,2 m/s)
Pag.20
Standard display Navigation display
fixed
hang-glide
FAI cylinder
wayp.
name
wayp.
distance
TEM P
TIM E
utc time
PRESS
press.
wayp
name ratio
requir..
temp.
COMPASS
compass
CHRONO
chrono
voltmeter
blinking
hang-glide
utc
time
TIM E