Web configuration commands
XLR PRO Radio Frequency (RF) Modem User Guide
48
Web configuration commands
Ethernet RF bridging commands
AT command options
Command
Name and description
Range
Default
HE
Web Configuration Enable
. Enable or disable HTTP server on
the XLR PRO for configuration via web browser.
0
- Disable web configuration
1
- Enable web configuration
0 - 1
1 (Enabled)
HU
Web Configuration User Name
. The user name used to access
the web configuration page.
Up to 63 ASCII
characters
admin
HW
Web Configuration Password
. The password used to access
the web configuration page. This command is write-only; it
cannot be read. Attempts to read HW will return an OK status.
Up to 63 ASCII
characters
password
Command
Name and Description
Range
Default
BE
Ethernet RF Bridging Enable
. Enable or disable Ethernet RF
bridging. When enabled, Ethernet traffic can be passed
between up to 16 XLR PROs on the same RF network.
0
- Disable Ethernet RF bridging
1
- Enable Ethernet RF bridging
Note:
If two XLR PROs are connected to the same Ethernet
switch, a switching loop may occur.
0 - 1
0 (disabled)
BA
Bridge Destination MAC
. The destination RF MAC address to
use for Ethernet RF Bridging. 0xFFFF is used as a broadcast
address.
0 -
0x0013A200FFFFFF
FF
0xFFFF
Command
Name and description
Parameter range
Default
CC
Command Sequence Character
. Set or read the character to
be used between guard times of the AT Command Mode
Sequence. The AT Command Mode Sequence causes the XLR
PRO to enter Command Mode (from Idle Mode).
0 - 0xFF
Recommended:
0x20 - 0x7F
0x2B
(ASCII “+”
character)
CN
Exit Command Mode
. Explicitly exit the XLR PRO from AT
Command Mode. Changes made in command mode will be
applied, but not written to flash.
n/a
n/a