Digi TransPort WR11, Руководство пользователя

Страница: 543 / 866

Configure legacy protocols Configure TPAD parameters
Digi TransPort WR Routers User Guide 543
Use merchant Number
Inserts a merchant number into the APACS 30 string when the locally connected equipment does
not transmit a merchant number.
Use Connect String
A string sent to the user’s terminal when an outgoing TPAD call has been connected, instead of
the normal ENQ character. For example, you could use this setting to make a TPAD connection
look like a PAD connection by specifying CON COM as the connect string.
The polling character set is c
A string that specifies a character or set of characters to be treated as polling characters. The
router responds to any of these characters using ACK. This parameter should normally be left
blank.
Enable Message Numbering
When enabled, the router overrides the message numbering of the local equipment and
substitute its own message numbering in the APACS 30 data. This is useful when the locally
connected equipment does not automatically increment the APACS 30 message number.
Disable Direct Mode
Enabling this setting will prevent the router from automatically using Direct Mode (see below)
when it receives an APACS 30 packet without any call set-up.
Boot to Direct Mode
Direct mode is a mode of operation whereby the router automatically routes APACS 30 packets
to their destination without the terminal having to perform any call control. If this parameter is
set to Yes , the next time the router is rebooted, it operates in direct mode. For direct mode to
work you must set up the appropriate addressing information, such as Transport protocol, NUA,
NUI, IP address etc. If this parameter is not enabled, the router still tries to use direct mode if it
detects that it is required, due to the absence of call control information. Use this parameter
when the router cannot automatically determine whether or not to use direct mode.
Use response code n in “unable to authorise” message
This parameter only applies when the router is operating in direct mode. In cases where the
router is unable to send the APACS 30 packet to the remote host, it replies to the terminal with
an unable to authorize message. By default, this message contains a response code 05 , which
means declined. Entering a number for this parameter causes the router to use that number in
place of the default response code. A value of 0 prevents the router from replying.
Clearing time n milliseconds
The clearing time, in milliseconds, that an X.25 call is left open after receiving a response from
the host. Each response from the host resets this timer.
Delay transmitting the APACS 30 string for x milliseconds after connecting to X.25 host
Setting this parameter causes the router to pause for the specified number of milliseconds in
between successfully connecting to the remote X.25 host and transmitting the APACS 30 string.