Digi TransPort WR11, Руководство пользователя

Страница: 585 / 866

Configure legacy protocols Configure X.25 parameters
Digi TransPort WR Routers User Guide 585
Calling user data
The calling user data field for a normal call can contain up to 12 bytes of user data. If the first
character is an exclamation mark (!), the PAD omits the 4-byte protocol identifier, and allows the
full 16 bytes as user data. The same is true for a fast select call, except the maximum amount of
user data is increased from 124 to 128 bytes. When entering user data, you can use the tilde
character (

) to toggle between ASCII and binary mode. In ASCII mode, data is accepted as
typed, but in binary mode, you must enter each byte as the required decimal ASCII code
separated by commas. For example, to enter the data Line1 followed by [CR][LF] and Line2 ,
enter:
DLine1~13,10~Line2
CLR command: Abort a CALL command
To abort an X.25 CALL, use the X.28 CLR command, do one of the following:
▪
Press [Enter] .
▪
Drop DTR from the terminal while the call is in progress. Dropping DTR will also terminate an
established call.
If a call is terminated by the network or by the remote host, the router returns a diagnostic message
before the NO CARRIER result code. Messages can be numeric or verbose, depending on the setting
of the ATV command.
Verbose messages and their numeric codes
The following table lists the verbose messages and equivalent numeric codes:
Note The router may abbreviate some verbose messages.
Code Verbose message
1 Unallocated (unassigned) number
2 No route to specified transit network
3 No route to destination
4 Channel unacceptable
6 Channel unacceptable
7 Call awarded and being delivered in an established channel
16 Normal call clearing
17 User busy
18 No user responding
19 No answer from user (user alerted)
21 Call rejected
22 Number changed
26 Non-selected user clearing