4.4.4. Replace the tilt actuator of the
tilt/lift interface
TBD
4.4.5. Replace the lift actuator of the
tilt/lift interface
TBD
4.5. Legrests
4.5.1. Replace the actuator of a
powered legrest
1. Follow the preparation (see 4.1).
2. Lift the legrest out of the wheelchair.
3. Remove the tie wraps and disconnect
the actuator cable from the legrest.
4. Remove the screws and bushes (A
figure 19).
5. Remove the old actuator (B).
6. Put the new actuator in the legrest.
7. Connect the actuator cable.
8. Put the connector cable into the
groove of the legrest and fasten the
connector cable with tie wraps.
9. Make sure that you leave enough free
cable length to let the actuator reach
its full length.
10. Check the functionality of the actuator.
A
A
A
B
19
18
17
4 Replacements and adjustments
20 - SANGO ADVANCED / SLIMLINE