4.3. Dahl preparation
Warning!
Dahl car docking is not possible in
combination with 78Ah batteries.
4.3.1. Replace the slider
To mount the Dahl docking plate the
sliders needs to be replaced (side by side).
1. Remove the cables if needed
2.
Remove the allen screws (A figure 12)
and battery cover (B).
3. Remove the allen
screw (C) and lower
the back part of the seat mounting rail
(D).
4. Remove the allen screw (E), the rail
holder bracket (F). and hex head
screws and rings (G) to remove the
sliders with backrest frame out of the
seat frame.
5. Remove the lighting (H and L), if
applicable
6. Remove the screws and bolts (I) to
loosen the sliders (J).
7. Take the nuts (K) from the old slider
and place them in the new slider.
8. Mount the lighting with the new
(longer) allen
screw (L).
9. Mount the sliders and backrest in
reverse order.
4.3.2. Mounting the Dahl locking plate
Warning!
• A crash test with Dahl was performed
on this wheelchair according to ISO 7176-19 (2008) with a dummy weight of 77
kg.
• The Dahl docking station is only allowed to build into a vehicle by trained and
authorized staff of a registered car adaptation company. For ordering the Dahl
docking and its accessories, please contact Dahl Engineering in Denmark for
further details www.dahlengineering.dk.
To mount the Dahl docking station our preparation kit (
SPARES 5000062) and
the following Dahl parts are needed:
• 500561 Docking plate (C)
• 502800 High grade steel Torx 27 bolts M8 Quality 14.9 (D)
1. Remove the battery slide plate and the batteries (see 4.2.8).
2.
Mount the battery box fixation screws 4x (A figure 13).
3. Position the Dahl support plate (B) in the battery box.
4. Mount the Dahl locking plate (C) under the battery box with the special Dahl
nuts (E) and the high grade steel Torx bolts (D) through the Dahl support plate
A
B
C
F
I
J
G
E
K
D
H
L
A
B
C
D
E
F
12
13
SANGO ADVANCED / SLIMLINE - 17
