4.4. Interface (all types)
4.4.1. Adjust the centre of gravity
(not recommended)
The position of the interface can be
adjusted in order to give the wheelchair
better driving characteristics. This position
depends on the seat depth and the drive
type.
1. Follow the preparation (see 4.1).
2. Set the interface in the maximum tilted
position for easy access.
3. Disconnect the interface cables from
the controller.
4.
Remove the screws (A figure 15) (4x).
5. Move the interface (B) to the desired
new position.
6. Fasten the screws (4x).
7. Check if the wheelchair is stable in all available positions for seat lift and tilt.
4.4.2. Adjust the height of the seat interface (not recommended)
The height of the interface can be adjusted in order to achieve the seat height as
required for the user.
1. Follow the preparation (see 4.1).
2.
Remove the srews (A figure 15) to remove the interface including the seating
system from the wheelchair carrier, for easy access.
3. Remove the 2 screws (C) on both sides.
4. Slide the interface bracket into the desired height.
5. Put the srews into one of the 4 holes to and thigthen the screws.
6. Put the interface including seating system back on the wheelchair carrier.
7. Check if the wheelchair is stable in all available positions for seat lift and tilt.
4.4.3. Replace the actuator of the tilt-
only interface
TBD
A
B
C
D
C
15
16
4 Replacements and adjustments
SANGO ADVANCED / SLIMLINE - 19