Dickey-John INTELLIAG AI-120, Руководство оператора

Страница: 192 / 195

OPERATOR’S MANUAL
AI-120 Virtual Terminal
11001-1606E-201703 Rev B
APPENDIX A / 185
APPENDIX D
SAMPLE JOB EXAMPLE
The following example depicts a typical setup of an As Applied job. If a field
does not already have a boundary mapped and coverage mapping is
required, these two activities can be performed at the same time.
1. Create a new boundary file.
2. Create a new job file. A job file is created after the boundary file so that
the job created is recalled when that boundary is recalled. Boundary
files will recall job files but job files will not recall boundary files.
3. Set the boundary offset
4. Press the
Start Coverage Map button.
5. Drive the desired field boundary.
6. Create a Curve Guidance pattern.
IMPORTANT: Typically, curves are selected for the first and second
lap. AB lines are selected and this guidance pattern is
used to complete the coverage of the remaining field.
This method is recommended for maximum coverage on
a rectangular shaped field.
7. Press the Complete Boundary button when reaching approximately
150 feet from starting point.
8. Perform another lap following the curve guideline of the first lap.
9. Create an AB Line Guidance pattern and complete field coverage
mapping.
10. At this screen, press the USB button to indicate a new file import.
11. Press the USB Transfer button to display files stored on the USB
device on the screen.
12. The “VRCXML” folder displays. To open files in this folder, press
VRCXML.
13. Press the Next button to proceed.
14. Select the tasks to be mapped to channels from the XML file.
15. Press the
Next button to proceed.