Diamond 10GN 1/1, Инструкция по установке, использованию и обслуживанию

Страница: 22 / 24

45
It is essential to disconnect the appliance if you are going to clean with water. Panels should not be
moved to access electrical components except by technical staff authorised to carry out maintenance and
repair operations
The inside of the cooler should be cleaned with great care.
8.1
PRICK PROBE (optional)
It is a frequently used component. Care should therefore be taken in where it is placed and it should be
kept clean to prevent the transmission of germs and bacteria from one foodstuff to another.
Care should be taken when cutting the product and also during its disconnection, and it should always be
handled on the thickest part and never the cable. It should be removed moving it alternately and turning
it to make it easier to take out and preventing it from being broken or bent.
It should be placed in the heart of the product and its biggest part.
To make this job easier, the prick probe should be put into place before removing the trays.
8.2
REGULAR CHECKS
To be carried out by the User
- It is recommended that there are no heat sources near to the cooler.
- The appliance should be well levelled to prevent excessive vibrations.
- The door Joint is in good working conditions and closes hermetically with the body.
- The electricity plug is correctly connected to the socket.
- Check that the water collection tray is in good working conditions (only in some models).
- Check that the drainage pipe in the chamber is not blocked.
- Check that the condenser circuit is not blocked with dust. If dirty, call the Technical Service for cleaning.
- Check that the evaporator fan grilles are not blocked by bits of food.
8.3
NON-USE FOR LONG PERIODS OF TIME
- Disconnect the appliance.
- Disconnect the connection cable.
- Empty and clean inside.
- Leave the door with an open gap for air circulation and to prevent mould from forming.
8.4
GENERAL MACHINE CHECKS
In the event of having to call for the technician, you can check the machine before ringing. In some cases
the operating faults that can occur are caused by something simple that the users themselves can solve.
The following are examples:
a) The Cooler does not work

Check that power reaches the Cooler, looking to see that the main switch is in the ON position, if it
has one, and that the display light up, after pressing any key, as it goes to Stand-by if 120 minutes
after finishing a cycle no key has been pressed.
b) Temperature too low

Check that there are no heat sources nearby.

Check that the room temperature is not above +30 ºC, which is the machine’s maximum operating
temperature.

Check that the goods load is perfectly positioned and does not obstruct the outlets of the inner fan,
and that the time it has been inside is sufficient to cool the products.

Check that the condenser is clean: You must bear in mind that the cleaner the refrigerator is the
greater the energy saving, particularly the condenser’s ribbing. The frequency of this cleaning will
be determined by the characteristics of the premises. If it is dirty, call the technical support service
to clean it.

Check that the doors close properly.
c) In the event of strange or excessive noise

Check the unit's levelling and that the doors close properly.

Check that there are no objects touching any of the cooler's moving components.

Check that the screws (at least the visible ones) are correctly tightened.
8.5
SPECIAL MAINTENANCE
(Authorised technical staff)