Diamond Products CORE CUT CC110-SS, Руководство оператора

Страница: 28 / 40

24
20. Retighten all loose jackshaft bearing bolts.
21. Turn off the engine.
22. Turn both engine belt tension bolts (two large bolts
at front of engine mount) clockwise to fully tighten
the engine belts. Both bolts must be at the same
height once the belts are tightened. Test the belt
tension and readjust as necessary. Refer to
Appendix C for additional information on belt tension
settings.
23. Retighten all four engine mount bolts.
Replacing the Polychain Belt (CC110D-DC)
Replace the polychain belt once it breaks. The belt only
requires tension adjustments when replacing.
Figure 29: Polychain Belt
1. Loosen all four engine mount bolts.
2. Turn both engine belt tension bolts (two large bolts
at front of engine mount) counterclockwise to loosen
the engine belts. Remove the belts from the
jackshaft sheave.
3. Loosen all four jackshaft bearing bolts.
4. Turn both jackshaft belt tension bolts (two large bolts
under jackshaft bearings) counterclockwise to
loosen the polychain belt.
5. Loosen the ferrule nut from the grease line and
remove the grease line from only one of the
jackshaft bearings. Remove two of the already
loosened jackshaft bearing bolts from the same
bearing as the removed grease line.
Figure 30: Grease Line and
Jackshaft Bearing Bolts
6. Remove all six bolts (four on front of plate, two on
bottom of plate underneath frame) from the skid
plate. Remove the plate.
7. Remove two of the four blade shaft bearing bolts.
The bolts being removed must be from the same
bearing! Loosen the ferrule nut from the grease line
and remove the grease line from the same bearing
as the removed blade shaft bearing bolts.
8. Loosen the remaining two blade shaft bearing bolts.
DO NOT remove them.
9. Remove the old belt from the blade shaft.
10. Fit a new polychain belt around the blade shaft from
the same side as the two removed blade shaft
bearings bolts and grease line. Slide the belt to the
center of the saw and fit it around the blade shaft’s
polychain sprocket. Bring the belt up through the
hole on the frame base.
11. Retighten all four blade shaft bearing bolts and
reattach the grease line to the blade shaft bearing.
12. Reinstall the skid plate at the front of the saw (using
six bolts.
13. To ensure safety, have a second trained operator
hold the jackshaft in place. Carefully fit the polychain
belt around the jackshaft bearing from the side with
the removed jackshaft bearing bolts and grease line.
14. Fit the belt around the jackshaft’s polychain
sprocket.
15. Retighten all four jackshaft bearing bolts just until
snug.
16. Turn both jackshaft belt tension bolts (two large bolts
under jackshaft bearings) clockwise to tighten the
polychain belt. Both bolts must be at the same
height once the belt is tightened. Test the belt
tension and readjust as necessary. Refer to
Appendix C for additional information on belt tension
settings.