Diamond Products CORE CUT CC110-SS, Руководство оператора

Страница: 25 / 40

CC110-SS and CC110D-DC Concrete Saw Manual 21
2. Add Mobil #30 oil or an equivalent to the Full Level
(Cold)
3. Replace the oil reservoir cap and tighten to secure.
line. DO NOT fill the oil above this line to
leave room for expansion.
Tightening the Transmission Drive Chain
Inspect the transmission drive chain regularly. Tighten
the chain as necessary and lubricate every 25-40 hours.
1. Remove old grease and dirt from the chain using a
degreasing agent and a brush. Wipe the chain clean
and lubricate with NGLI No. 2 premium lithium-
based grease.
2. Loosen the four bolts on the transmission mount.
Figure 22: Mount Bracket and Bolts
3. Loosen the nut on the tension bolt at the center of
the chain tensioning bracket (center bolt on bracket
in image above).
4. Turn the bolt clockwise to tighten the drive chain,
leaving a slight amount of slack in the chain. DO
NOT over-tighten!
5. Retighten the nut to secure the tension bolt.
6. Retighten the four bolts on the transmission mount
to secure.
Radiator
Clean the radiator daily.
Figure 23: Radiator Filer and Fan
1. Remove the radiator fan guard.
2. Remove the filter and grill from the fan housing.
3. Clean the filter by washing it out or using
compressed air to remove dirt particles. Replace the
filter when damaged or not cleanable.
4. Fit the grill and air filter back into the fan housing.
5. Place the fan guard over the filter inside the fan
housing.
6. Secure the guard to the fan housing using the metal
tabs.
7. Wipe down the radiator base to help prevent higher
operating temperatures. Use compressed air to
remove debris from the cooling fins or, if necessary,
use a pressure washer.
Note: Always use low air
and water pressure settings to avoid bending the
radiator fins; bent fins may prevent proper cooling
.