Diamond Products CORE CUT CC110-SS, Руководство оператора

Страница: 18 / 40

14
greater for proper transmission efficiency when
maneuvering the saw with power
3. Turn the
.
Hold/Release
Tasks Prior to Starting the Engine
knob clockwise to tighten the
knob and secure the engine rpm speed.
Complete the tasks listed below prior to starting the
engine to ensure a safe start:
•
Check fluids and fill to appropriate levels.
•
Turn off controls and switches.
•
Place speed control lever at neutral.
•
Remove tools from area.
Starting the Engine
1. Open the fuel shutoff valve.
2. Adjust the Vernier throttle to idle.
3. Insert the key into the ignition, turn it to
Start , and
release when the engine starts. Note: If the engine
does not start within 5 seconds, turn the key to Off
and try again approximately one minute later. Refer
to the engine manual for troubleshooting
recommendations after several failed attempts
4. Let the engine idle for several minutes. Check the
CANtrak GEM and all warning lights. Turn off the
engine immediately and fix any problems prior to
operating the saw.
.
5. Increase the engine speed slowly when starting a
cold engine. Adjust the engine speed as necessary
for maximum efficiency. Refer to the engine manual
for additional information.
Stopping the Engine
CAUTION
•
DO NOT leave the saw unattended until the
engine is off and the blade has stopped
spinning.
1. Place the speed control lever at neutral and raise
the blade from the cut.
2. Turn off all controls, switches, and water.
3. Decrease the engine speed to idle for several
minutes to cool down.
4. Turn the ignition key to Off
5. Close the fuel shutoff valve (if desired).
and remove the key.
Speed Control Lever
Figure 10: Speed Control Lever
Speed Control Lever
The speed control lever moves the saw forward and
backward at up to 200 ft/min.
Note: The engine must be
running at half throttle or greater to move the saw using
the speed control lever
.
1. Slowly push the lever toward “F”
2. Slowly pull the lever toward
to move forward,
and release when at the desired traveling speed.
“R”
3. Place the lever at
to move backward,
and release when at the desired traveling speed.
“N” to put the saw in neutral. DO
NOT assume at any time that neutral will act as a
brake.
Note: Always start the engine with the speed
control lever at neutral
Water Supply
.
The water supply cools the blade and minimizes dust
when cutting.
Note: Always test the water supply for
adequate pressure and flow prior to cutting
Using the Water Supply
.
1. Connect the water source hose to the garden hose
fitting on the dual water valve.
2. Connect one end of the water supply hose to the
water supply fitting on either water valve, depending
on the side being used for cutting.
3. Connect the other end of the water supply hose to
the blade guard. Note: Disconnect and reconnect
the water supply hose when moving the blade guard
to the opposite side of the saw
.