Diamond Products CORE CUT CC110-SS, Руководство оператора

Страница: 22 / 40

18
Figure 13: CC110-SS Transmission
Mount Bolts and Drive Alignment Bolt
1. Locate the transmission mount bolts and drive
adjustment bolt at the rear of the frame base.
2. CC110-SS:
3.
Loosen the two transmission mount
bolts located directly behind the adjustment bolt. DO
NOT remove the bolts.
CC110D-DC:
4. Turn the adjustment bolt clockwise to adjust the
alignment toward the right or counterclockwise to
adjust the alignment toward the left.
Loosen the three transmission mount
bolts (two of them are located directly behind the
adjustment bolt, and one (missing from picture) is
located on the opposite side of the transmission).
DO NOT remove the bolts.
5. Retighten the transmission mount bolts to secure.
Inner Blade Flange
Figure 14: CC110-SS
Inner Flange
Figure 15: CC110D-DC
Inner Flange
Installing the Inner Blade Flange
1. Inspect the inner flange for damages. Clean or
replace damaged components as necessary.
2. Place the flange onto the blade shaft.
3. Apply Loctite 262 (red) or an equivalent to the
setscrew threads.
4. Tighten the setscrew(s) into the back of the inner
flange to secure.
Removing the Inner Blade Flange
1. Remove both setscrews from the back of the inner
flange using an Allen wrench.
2. Carefully remove the flange from the blade shaft.
Front/Rear Wheels
WARNING
•
Raise the saw to a proper height for
access when working underneath
the saw. Use chocks to block the
wheels, and fit blocks or jacks under the frame
edges at the front and back of the frame for
additional support.
Figure 16: Front and Rear Wheels
Replacing the Front Wheels
Replace the front wheels when damaged and/or
affecting saw performance.
1. Move the saw to level ground. Use a jack to lift the
saw near the front wheels, and raise the front
wheels off the ground.
2. Loosen the setscrew(s) in the set collar.
3. Remove the set collar and wheel from the
undercarriage.
4. Place a new wheel onto the undercarriage and
replace the set collar.
5. Tighten the setscrew(s) into the set collar to secure
the wheel.
6. Replace the second front wheel as directed.
7. Slowly lower the jack and remove the jack stand
when the wheels are firmly touching the ground.