Diamond Products CORE CUT CC110-SS, Руководство оператора

Страница: 14 / 40

10
Fuel System
WARNING
•
Always use caution when refueling.
•
DO NOT operate the saw with a fuel leak.
•
DO NOT fuel the saw with the engine running.
•
DO NOT smoke or expose fuel to
open flames when filling the fuel
tank or working with fuel.
CAUTION
•
Clean up any spilled fuel prior to starting the
engine.
•
Fuel may seep out from the fuel cap vent
(applicable models) when raising the saw if the
fuel tank is overfilled.
Adding Fuel
1. Lower the saw to level the frame.
2. Turn off the engine and let the saw cool down.
3. Remove the fuel tank cap.
4. Fill the fuel tank with low sulfur or ultra-low sulfur
diesel fuel. DO NOT overfill the tank for expansion
purposes. Refer to the engine manual for
information on appropriate diesel fuels in normal and
cold weather temperatures.
5. Replace the fuel tank cap and secure.
Blade Guard
WARNING
•
DO NOT operate the saw with the blade guard
raised or removed.
•
DO NOT remove the blade guard with the
engine running.
•
Blade exposure should not exceed 180° while
cutting.
•
Always pivot the front of the blade
guard 180° (fully upward) so the
guard does not swing down
unexpectedly, which may cause
serious injuries.
•
When pivoting the front of the blade guard,
raise/lower it cautiously and slowly to avoid
serious injuries.
The blade guard shields the blade and must always be
in place when operating the saw. Regularly inspect the
blade guard and water tubes. Clean, repair, or replace
dirty or damaged components immediately.
Note:
Always use a guard size that matches the blade size.
Refer to the parts list for more information
Installing the Blade Guard
.
Note: Always install the blade guard with the blade off
the saw
.
1. Raise the saw slightly for access under the frame
base.
2. Rest the blade guard on the ground, and remove the
pivot bolt securing the front and back of the guard
together. Remove the front of the guard.
3. To ensure safety, have a second trained operator fit
the back of the guard over the blade flanges while
holding it in place against the side of the frame base.
4. Place a blade guard bolt through the bolt hole near
the back of the guard, and secure the first bolt for
the guard to the frame base through the bolt hole
near the back of the base.
5. CC110-SS:
6.
Place a blade guard bolt through the bolt
hole inside the guard, and secure the second bolt for
the guard to the frame base through the bolt hole
near the front of the base.
CC110D-DC:
7. To ensure safety, have a second trained operator
carefully lift the front of the guard and realign the
front and back of the blade guard. Replace the pivot
bolt to secure the entire guard together.
Place a blade guard bolt through both
bolt holes inside the guard, and secure the second
and third bolts for the guard to the frame through the
bolt holes on the front arm of the frame.
8. Connect the water supply hose to the water valve
and blade guard.
Figure 6: Blade Guard Installed
Removing the Blade Guard
Note: Always remove the blade guard with the blade off
the saw
.