diamond mowers Drum Mulcher OD Pro X, Руководство оператора

Страница: 34 / 44

© Diamond Mowers®, LLC
MAINTENANCE
Twin Chisel® Planer Teeth:
•
Teeth
(1)
should be inspected every
10 hours or daily.
◦
Inspect the teeth
(1)
for any chips
or damage.
◦
Sharpen
(2)
, rotate, or replace
as needed.
-
NOTE: The tooth must be
rotated or replaced when the
sharpenable
(2)
area (shaded in
blue) is completely worn away
down to the bottom of the
depth gauge
(3)
.
◦
Tighten any loose teeth
(1)
.
LOOSE TEETH
BOLTS
ROTATING
TEETH
SHARPENING
TEETH
REPLACING
TEETH
Use a torque
wrench set to
torque to
120ft-lbs (163Nm).
DO NOT over-
torque as you
could strip the
threads and allow
it to become loose.
The majority of
cutting will be
done with the
tooth’s outside
leading edge. When
this edge has
been worn down
to the bottom of
the depth gauge
from sharpening or
wear, the tooth can
be rotated 180
o
in
its tooth holder to
expose the fresh
edge.
Lightly sharpen the
outside leading
edge of the
tooth with a 4-1/2”
(114mm) angle
grinder, equipped
with a flap style-
sanding disc.
DO NOT use a hard
grinding disc. A
hard grinding disc
will rapidly wear
away the hardened
outer surface of
the tooth.
If the bottom of
the depth gauge
has been reached,
you will need to
rotate or replace
the tooth.
Remove the bolts
and flat washers.
Replace the tooth.
Using new
hardware, hand-
thread the bolts/
washers or use an
impact wrench set
on low.
DO NOT use
Loctite. Use a
torque wrench set
to torque to
120ft-lbs (163Nm).
DO NOT over-
torque as your
could strip the
threads and allow
it to become loose.
TWIN CHISEL® TEETH MAINTENANCE
(1)
(3)
(2)
34