DHS Systems TM 95263 00, Руководство по эксплуатации и обслуживанию

Страница: 70 / 132

DHS Systems, LLC TM 95236-00 0006
0006-8
No rights are conveyed except as indicated in the legend on the cover of this document.
Audio Set Up
Set Master Volume
The master volume control is located on the top right of the main page titled ‘Volume.’ It controls the
overall output volume level through the rear I/O panel connector labeled SPEAKER.
1. Locate the
Volume control on the upper right corner of the main screen (Figure 9, Item 1).
2. Press and hold the
Up Arrow button (Figure 9, Item 2) to raise the output volume to the desired level.
3. Locate and press the
Mute Audio button (Figure 9, Item 3) to mute all audio output through the rear I/O panel
connector labeled SPEAKER.
4. Press and hold the
Down Arrow button (Figure 9, Item 4) to lower the output volume to the desired level.
6
2
3
4
5
7
8
9
}
1
Figure 9. Audio Control Panel.
Set Audio Input Volume
1. Locate and press the
Audio button (Figure 9, Item 5) to access the Audio Panel.
Each MIC input has four controls associated with it on the Audio Panel. The controls include automatic
gain control AGC), phantom power (P-PWR), mute, and input volume.
2. Locate the two MIC Input controls (Figure 9, Item 6) on the lower left side of the Audio Panel
3. Identify the
MIC Input 1 Control (Figure 9, Item 7) located on the bottom left of the Audio Panel.
4. Press
AGC to activate the Automatic Gain Control to keep the incoming audio level at a defined level, i.e., if
the input signal level drops below a predefined level, the AVCS Mixer will increase the gain, if the signal
raises higher than the preset level, the AVCS Mixer will attenuate the input signal.