DHS Systems TM 95263 00, Руководство по эксплуатации и обслуживанию

Страница: 118 / 132

DHS Systems, LLC TM 95236-00 0016
0016-2
No rights are conveyed except as indicated in the legend on the cover of this document.
CLEANING THE AVSC
INITIAL SETUP:
Tools and Special Tools
Damp Cloth
Stiff Bristled Brush
Materials/Parts Equipment Condition
Water Equipment Powered Down
De-natured Alcohol Power Source Disconnected
WARNING
Voltage sources, in addition to being an electrical shock hazard, may also potentially produce
serious burns. Care should be exercised when using water around exposed power
connections. Ensure that all power to the system has been shut off before disassembling and
cleaning the components of the AVCS (MINI).
C AUTION
Use of a damp cloth is authorized for cleaning the case and cables but care should be
exercised to ensure that water does not get into the connection of the cables or the electrical
components. Damage to the components may result from water, if water gets into the
connections, blow the connections out with compressed air, or allow to air dry before
connecting back to equipment.
SERVICE
1. Verify that the AVCS (Mini) has been shut down and the power source has been disconnected.
2. Disconnect all cables attached to the AVSC.
3. Clean off any severe dirt or mud from the outer case using a stiff bristled brush.
4. Use a vacuum or compressed air to remove any loose debris from inside the AVSC case.
5. Clean the outer surface of the case and the interior surface of the case using a damp cloth. Use care not to
get any water on the face of the electrical components.
6. Dry any excess water from the inside of the case using a lint free cloth.
7. Clean the face and rear of electrical components using Electronic Anti-Static/Alcohol Free Cleaning Wipes.
8. Clean out the connectors on the rear of the AVSC using compressed air to blow out any debris.
CAUTION
Do not use any water to clean out the connectors. Water can cause corrosion or rust
preventing the connectors from making a proper connection.
9. Ensure the dust covers seal properly.
END OF TASK