Dexter Laundry 450ETC1-18030.1, Инструкция по эксплуатации, Страница: 137 / 158

137
WARNING! Fill the product with water only until water can drain
from the opening in the plug. During use the water level must
never drop below the MIN marking.
Product damage! Fill the tank only with clear water. Never use
chemicals or cleaning agents. This can cause irreparable damage
to the product.
INSTALLING THE WATER RESERVOIR PLUG
• Raise the 45° vertical fence approx. 45° and remove.
• Locate hole on bottom of water reservoir.
• Replace 45° vertical fence.
FILLING THE WATER RESERVOIR
• Raise the 45° vertical fence approx. 45° and remove.
• Fill the reservoir with water only until water can drain from the opening in the plug.
• Ensure that water just cover the disc edge (no more than ¼ of the disc is submerged in water).
• Replace 45° vertical fence.
7. OPERATION
ON/OFF SWITCH
WARNING!
Before starting:
• Ensure that there are no visible defects.
• Ensure that there is nothing in the work area that may hamper the work to be performed.
• Ensure that there is sufficient cooling water.
• Ensure that the guard is correctly mounted.
• Ensure that no one other than the operator is in the working area.
• For safety reasons replace the tool if it is found to be damaged in any way.
• To switch on, press the “1” on the on/off switch.
• Before you begin cutting, wait until the cutting wheel has reached maximum speed and wait for the
cutting disc to get wet.
• To switch off, press the “0” on the on/off switch.
• Pre-cut 2cm at the end side for better cutting surface.
TO MAKE A CROSS CUT
• Cross cuts are straight 90° cuts. The material is fed into the cut at a 90° angle to the cutting disc. Using
a marker or grease pencil, mark the area to be cut on material.
• Adjust parallel cutting guide to desired position and secure tightly.
l cutting guide.
• Make sure the material is clear of the cutting disc before turning on the saw.
• Turn the on/off switch to the on position.
• Let the cutting disc get up to full speed and wait for the cutting disc to get wet before moving the
material into the cutting disc.
• Hold the material f irmly against the parallel cutting guide and feed the material into the cutting disc.
• When the cut is made, turn the saw off. Wait for the cutting disc to come to a complete stop before
removing any part of the material.
TO MAKE A 45° DIAGONAL CUT
45° diagonal cuts are also referred to as “TO MAKE A CROSS CUT”.
• Using a marker or grease pencil, mark the area to be cut on material.
• Slide mitre cutting guide onto parallel guide from front.
• Set the parallel cutting guide to desired width, and tighten the locking knob to secure in place.
FR
ES
PT
IT
EL
PL
UA
RO
EN