Dexter Laundry 450ETC1-18030.1, Инструкция по эксплуатации, Страница: 134 / 158

134
FR
ES
PT
IT
EL
PL
UA
RO
EN
Sound and vibration
The noise emission values were measured in accordance with EN 62841-1:2015.
Note: Recommendation for the operator to wear hearing protection.
that the declared noise emission value(s) have been measured in accordance with a standard test
method and may be used for comparing one tool with another;
that the declared noise emission value(s) may also be used in a preliminary assessment of exposure.
the noise emissions during actual use of the power tool can differ from the declared values depending
on the ways in which the tool is used especially what kind of workpiece is processed;
need to identify safety measures to protect the operator that are based on an estimation of exposure in
the actual conditions of use (taking account of all parts of the operating cycle such as the times when
the tool is switched off and when it is running idle in addition to the trigger time).
The machine is designed for operating in S1 mode (continuous operation) under 450W power and S2
mode (short-term operation) under 550W power. S2 mode means that you can operate the machine for
an uninterrupted period of 10 minutes at most with a nominal load after this period of time has
elapsed, you must switch off the appliance and allow it to cool down completely. Afterwards, it can be
used again for a maximum of 10 minutes.
4. TECHNICAL DATA
Nominal voltage
Nominal frequency
Nominal power
No load speed
Weight
Max. mass of workpiece
Max. demensions of workpiece
Diameter of diamond cutting wheel
Bore diameter of diamond cutting wheel
Maximum cutting depth for a 90° cut
Maximum cutting depth for a 45° cut
Table’s tilting range
Miter cutter range
Protection class
230 V~
50 Hz
S1: 450W; S2 : 550W 10min
2950 min -1
14.4 kg
10 kg
450 x 380 x 30mm
180 mm
22.2 mm
30 mm
14 mm
0° / 22.5° / 45°
0-45°
I
5. BEFORE STARTING THE EQUIPMENT
• The machine must be set up to a stand or work bench or similar. Before setting up the machine,
choose a stable surface, that is free of obstacles (except materials to be cut) and adequately lit.
• All covers and safety devices must be properly fitted before the equipment is switched on.
• The cutting wheel must rotate smoothly.
• Check that the voltage on the rating plate is the same as your supply voltage before you connect the
equipment to the power supply.
• Always stand on the front of the machine when operating.
L
pA
sound pressure level
L
WA
sound power level
Uncertainty K
75 dB(A)
88 dB(A)
K
pA
=3 dB(A); K
WA
=3 dB(A)