DeWalt DCB107, Оригинальное руководство пользователя

Страница: 19 / 28

17
English
gun trigger is released, the water flow will stop immediately
and the engine should shut off in approximately 10 seconds.
When the spray gun trigger is squeezed again, the engine
will restart and the water flow will begin again.
3. Place the fuel valve lever in the OFF position.
Fig. BB
4.
PREssUREREADY® system mode only:
Remove the
battery pack and store properly.
-
To remove battery pack (Fig. P): Depress the battery
release button 24 on the battery and pull battery pack
out from the battery housing.
WARNING:
Risk of Damage. DO NOT store battery pack
in pressure washer when not in use. Remove battery pack
after every use.
5. Turn cold water source off.
6. Pull spray gun trigger to relieve any water pressure in hose
or spray gun.
7. Refer to
Storage
for proper storage procedures.
MAINTENANCE
WARNING: Risk of burning. When performing
maintenance, you may be exposed to hot surfaces, water
pressure or moving parts that can cause serious injury
or death.
WARNING:
Risk of fire. Always disconnect, spark plug
wire, let the engine cool and release all water pressure
before performing any maintenance or repair. The engine
contains flammable fuel. Do not smoke or work near open
flames while performing maintenance.
To ensure efficient operation and longer life of your pressure
washer, a routine maintenance schedule should be prepared
and followed. If the pressure washer is used in unusual
conditions, such as high temperatures or dusty conditions, more
frequent maintenance checks will be required.
Engine
Consult the engine instruction manual for the manufacturer's
recommendations for any and all maintenance.
nOTE:
The pressure washer frame is equipped with an oil drain
hole to help make changing the engine oil easier.
Pump
The pump was filled with oil at the factory. The pump on
this unit is maintenance free and requires no oil. If there is a
problem with the pump contact us at AUST 1800 841 749/
NZ 0800 467 813 or reference the
Troubleshooting Guide.
Nozzle Cleaning (Fig. CC, DD)
If the nozzle becomes clogged with foreign materials, such as
dirt, excessive pressure may develop. If the nozzle becomes
partially clogged or restricted, the pump pressure will pulsate
and when operating in PRESSUREREADY® system mode the
engine may shut off due to the low water flow. Clean the nozzle
immediately using the nozzle kit supplied and the following
instructions:
1. Shut down the pressure washer. See
Shutting Down
for the
correct procedure.
2. Disconnect the spray wand from the spray gun.
3. Remove the high pressure nozzle from the spray wand.
Remove any obstructions with the nozzle cleaning tool 29
provided and back flush with clean water.
Fig. CC
29
4. Direct water supply into spray nozzle to back flush loosened
particles for 30 seconds.
Fig. DD
5. Reconnect the nozzle to the spray wand.
6. Reconnect spray wand to gun then turn on water supply.
7. Start pressure washer and place spray wand into
high pressure setting to test. See Starting for the
correct procedure.
To Clean the Water Inlet Filter (Fig. EE)
This filter screen 14 should be checked periodically and
cleaned if necessary.
1. Shut down the pressure washer. See
Shutting Down
for the
correct procedure.
2. Remove the filter screen 14 by grasping the end and
removing it from water inlet of pump.
3. Clean filter by flushing it with water on both sides.
4. Reinsert filter into water inlet of pump. If the filter is not flat,
convex side should face out.
nOTE: Do not operate pressure washer without filter
properly installed.
Fig. EE
14