DeWalt DCB107, Оригинальное руководство пользователя

Страница: 13 / 28

11
English
ASSEMBLY
Pressure Washer Assembly (Fig. B, C–F)
1. Slide the handle assembly 8 onto the frame 6 and secure
with saddle bolts 20 and knobs 21 .
Fig. C
8
6
20
21
22
20
21
8
2. Align holes in the top handle 22 with the mounting holes
in the handle assembly 8 . Insert saddle bolts 20 through
aligned holes and secure top handle to handle assembly
with knobs
21 . Tighten until snug.
CAUTION: Risk of personal injury. Avoid placing
hands between handle and frame when assembling to
prevent pinching.
3. Attach high pressure hose 9 to spray gun 3 . Make sure it
is secure.
Fig. D
9
3
4. Connect wand 5 to spray gun 3 . Make sure connection
is secure.
Fig. E
5
3
5. Remove the five coloured quick-connect nozzles from the
plastic bag and insert them into correct grommet on the
nozzle holder.
Nozzles are colour coded to match coloured
nozzles on panel assembly.
Fig. F
6. Check the tyre pressure and add air if needed.
nOTE: Air tanks, compressors and similar equipment used
to inflate tyres can fill small tyres similar to these very rapidly.
Adjust pressure regulator on air supply to no more than the
rating of the tyre pressure. Add air in small increments and
frequently use the tyre gauge to prevent over inflation.
WARNING: Risk of bursting. Use a tyre pressure gauge
to check the tyres pressure before each use and while
inflating tyres; see the tyre sidewall for the correct
tyre pressure.
OPERATION
Instructions for Use
WARNING:
Always observe the safety instructions and
applicable regulations.
WARNING: Use only D
e
WALT battery packs and chargers.
Pressure Adjustments
The pressure setting is preset at the factory to achieve
optimum pressure and cleaning. To lower the pressure, follow
these instructions.
1. Back away from the surface to be cleaned. The further away
the nozzle is, the less the pressure will be on the surface to
be cleaned.
2. Change to the 40˚ nozzle (white). This nozzle delivers a less
powerful stream of water and a wider spray pattern. Refer to
spray Wand nozzles .
3. This pressure washer's high pressure pump is equipped with
an adjustable unloader 30 (Fig. G) feature that allows the
pressure setting to be adjusted. To lower the pressure, turn
the pressure control knob on the pump counterclockwise
to the desired pressure. To return the pump pressure to the
factory setting, turn the pressure control knob on the pump
clockwise until it stops.
NOTICE:
DO NOT try to turn pressure regulator knob past
the built-in stop or damage to the pump will result.
NOTICE:
DO NOT overtighten the pressure control knob.
If overtightened the knob COULD break and result in
immediate loss of water pressure and costly repairs to
the unit.
NOTICE: DO NOT attempt to increase pump pressure. A
higher pressure setting than the factory set pressure may
damage the pump.
Fig. G
30