DeWalt D28754, Инструкция по эксплуатации

Страница: 8 / 36

English
6
8. Replace the bail handle with the bottom insulators 18 ,
top insulators 17 and the 2 hex bolts 16 then tighten
securely to 75 in-lbs. Refer to Figure B for orientation of
the bail handle.
WARNING: Plastic insulators must be assembled to
hex bolts and bracket as shown in Figure C. Failure to
do so may result in electric shock injury.
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Spindle Lock Button (Fig. D)
The spindle lock button
8
is used to lock the spindle
when changing accessories. To engage the spindle lock
button, disconnect the tool from the power supply and be
sure switch is in off position. Depress the lock button and
turn the wheel and spindle until the lock button engages
the spindle. Use supplied wrench to unscrew the spindle
nut
9 and remove or mount accessories. Spindle threads
are right hand.
Accessories
The capacity of this tool is 12" (305 mm) diameter by 1/8"
(3 mm) thick cutting wheels.
WARNING: Since accessories, other than those
offered by D
e
WALT , have not been tested with this
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only
D
e
WALT
recommended accessories should be used with
this product.
WARNING: Accessories must be rated for at least
the speed recom mended on the tool warning label.
Wheels and other accessories running over rated
speed can fly apart and cause injury. Accessory
ratings must always be above tool speed as shown on
tool nameplate.
WARNING: Handle and store all abrasive wheels
carefully to prevent damage from thermal shock, heat,
mechanical damage, etc. Store in a dry protected area
free from high humidity, freezing temperatures or
extreme temperature changes.
Recommended accessories for use with your tool
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact
D
e
WALT Industrial
Fig. B
6
1
7
5
4
8
16
14
13
15
Fig. C
17
16
18