Devolo G3-PLC Modem 500k, Руководство пользователя

Страница: 18 / 42

Configuration
devolo G3-PLC Modem 500k
18
Click Save to save the settings of the respective area of the configuration interface.
Click Back to leave the respective area of the configuration interface.
Language selection
Select the desired language in the language selection list.
4.1.1Overview page
The five central areas of the configuration interface are shown on the main menu. Click
the button of an area to move directly into it.
쎲
The Network configuration area lets you change network and time control set-
tings.
쎲
The Modem configuration area lets you specify the mode of the device and the
settings for data communication.
쎲
The Device status area contains specific device data.
쎲
The Update firmware area lets you update the firmware of your device.
쎲
Define the access restrictions for your device or the G3-PLC network in the Secu-
rity area.
쎲
Configure piping of the serial interface over the G3-PLC network in the Serial
interface area.
4.2 Network configuration
The Network configuration area lets you change network and time control settings.
4.2.1IPv4 address
As a component of your network, the G3-PLC Modem 500k communicates using the
IPv4 protocol. The IP address required for this can either be entered manually as a stat-
ic address or obtained automatically from a DHCP server.
The option Use this to accept network settings automatically from a DHCP server
is enabled in the factory defaults. If a DHCP server for the assignment of IP addresses
is present in the network and the
Use network settings provided by a DHCP server
option is enabled, the G3-PLC Modem 500k receives an address automatically from
this.