Devolo G3-PLC Modem 500k, Руководство пользователя

Страница: 14 / 42

Installation
devolo G3-PLC Modem 500k
14
쎲
Now, configure the device as a "PAN coordinator" and assign it a unique PAN ID.
Approximately 1 minute after confirming the configuration change by selecting
Save , the PLC link LED lights up in green , signalling the online link status. This
means that the PAN coordinator is now ready to pair with PAN clients. Initially,
the network access whitelist is still empty.
Once you have assigned a static IP to the devices (either manually or
through configuration of a DHCP server connected to the PAN coordinator),
it is recommended that you also write down this address in the network
plan.
3.3.2PAN client installation
Each G3-PLC Modem 500k is configured as a PAN client by default and does not nor-
mally require any additional configuration.
After switching it on, the modem immediately searches for an available PAN coordi-
nator.
Please note that if you establish a G3-PLC network by first setting up the PAN clients
in order to determine the best possible location for the PAN coordinator later on, be
aware that no communication is possible within the G3-PLC network until the PAN
coordinator is installed and online.
Once the network is installed and online, the PAN client can immediately pair with the
PAN coordinator.
Upon successful pairing , the PLC link LED lights up in green .
If the PLC link LED is still lit in orange after several minutes, then the PAN
client could not connect to any PAN coordinator. This may be because the
distance is too large or interference in the mains supply is preventing the
connection or the automated PAN search is deactivated because the device
is no longer set to the factory defaults.
Initial pairing on the network can take place using other PAN clients (as repeaters) at
this point, provided that these clients are paired with the PAN coordinator.
As soon as the PAN client has successfully paired with the PAN coordinator, the in-
stallation of this device is complete.
Before you install the next PAN client, write down the MAC address of the
modem and the installation location. The MAC address is listed on the label
of the device housing.