Detex DSI ES9000-48, Инструкции по сборке, установке и эксплуатации

Страница: 6 / 27

6 INS9000 220523
DESIGNED SECURITY INC.
1402 Hawthorne Street Bastrop, Texas 78602
800-272-3555
Fax 512 321 9181
www.dsigo.com
Email: dsi@dsigo.com
LAYOUT AND MOUNTING
PEDESTAL LAYOUT

Using a chalk line, or equivalent method, lay out the pedestal arrangement. Pedestal positions should be parallel and
square with each other.
PEDESTAL SPACING
 Verify the “on centers” measurement to accommodate the pedestal width and clearance for barrier operation prior to
setting anchors or drilling for conduit.

Lanes are specified by open walkway space—typically 36”. The pedestals measure 8” wide, so, in this case, the on-
center measurement would be 44”

This spacing will maintain a minimum 3.5” between the extended gate panels.
After going over the details of the installation with the architect or designer and you have determined planned
spacing and orientation of the system, you may have some questions regarding how to lay out the array of
pedestals with the most accuracy in regard to alignment.
Here are two alignment tips which may be helpful:
Tip 1- Determining a “Right Angle” for alignment.
 Without getting into a lot of math, there is a simple way to build a Right-Angle
Triangle by using sides of 3', 4' and 5'.
 This method is based upon a geometric Theorem [a² + b² = c²]. Using this you
can calculate the length of the long side (C) of any right-angle triangle based
upon the known length of the other two sides.
Use this device to verify alignment by referencing a chalk line on the
floor.
Tip 2 - Alignment Check
 Once you have established a known right-angle to the initial chalk-line, you will
want to verify that each pedestal will be aligned to the adjacent pedestal.
 You may do this by choosing a point on each end of a pedestal mount, (for
instance the center of a mounting hole), you can measure in an “X” pattern from
one point to it’s opposite in the “X”.

When the pedestals are the correct distance apart and both lengths of the “X” are
equal, the pedestals are in alignment.
ANCHORS

Use appropriate anchor system for the mounting surface.
 DSI recommends 1/2” diameter anchors
A
C
B
PE
DEST
A
L
CHALK LINE
PE
DEST
A
L
PE
DEST
A
L