Deprag 346-138U, Руководство по эксплуатации

Страница: 16 / 40

16
6 Assembly - Disassembly
Disassembly: (see Spare Parts Drawing)
Prior to disassembly, disconnect equipment from air
supply! Only experienced maintenance personnel may
assemble or disassemble this equipment.
After repair or maintenance, verify that equipment runs to specification!
Principally, use only DEPRAG original spare parts. Otherwise, a reduction
in equipment power-output and an increased maintenance-requirement
occurs. If NON-DEPRAG parts are installed, DEPRAG is justified to void
any existing warranty and liability obligations.
Attention:
Never clamp motor housing into a vice, without the usage of the
protective chucking jaws, since damage to motor-housing and
internal parts is unavoidable.
Attention:
Motor- and gearing parts may be damaged if dropped!
For disassembly proceed in the sequence described below:
1. Disconnect the machine from air supply.
2. Unscrew clutch bearing (AF 27, left-hand thread) complete with spring
sleeve (Accessories - Optional equipment).
3. Take out the complete clutch.
4. Unscrew the quick release nipple 804271 (AF 17) and remove the o-ring
802514 and the silencer 402378.
5. Clamp the exterior motor housing 3979471 with chucking jaws 462506
into a vice.
6. Unscrew threaded fitting 402372 by means of pin wrench 462581.
7. Pull out the guide 398706 and the silencers 328233 and 313145.
8. Loosen the threaded fitting 384731 (AF 12) by means of key 462125 and
take off the complete reversal 388897 E.
9. Slide the complete motor- and gearing package out of the exterior motor
housing 3979471 in direction of the clutch.
10. Remove the 4 balls 802172 resp. 802201 from the valve housing 396575
and take off the o-ring 829466.