Denyo GAW-185ES2, Инструкция по эксплуатации

Страница: 21 / 49

Periodic inspection and maintenance GAW-185ES2
- 35 -
3-2 Startup and running
Make sure that no obstacle is located in the range of 1 m from the welder, and send a
signal to the people located around the welder, before starting the engine. Furthermore,
lock the engine while it is running, so that operation by anybody having no knowledge on the
welder or welder operating skill is disabled.
▪
Select the using frequency by the frequency select switch located inside the door.
[Caution] : Do not change the frequency, while the engine is running.
▪
Slow down switch “ ON “ position.
▪ Make sure the machine abnormality and close the door.
[Caution] : If no ignition tone is produced even after turning the starter motor for about 10
seconds, it is essential to allow a pause time of at least 10 seconds in the state where the
starter switch is returned to the
“STOP” position, before turning the starter motor again.
[Caution] : If the starter switch does not return to the position of the "operation"
automatically, please return to the "operation" manually. Could be damaged by the
starter motor continues around.
Fuel cock “Open”
Starter switch “Run” to “Start”
Starter switch “Run” position
If engine start is a cold weather, choke is
close position. Adjust the opening of the
choke knob according to operating
conditions. When the air temperature is
high, close the choke knob halfway or
open it all the way
Warm-up
(After the engine start, let the machine idle more than 5 minutes to warm-up )
Choke “OPEN”
Choke “CLOSE“
Choke
Open Close
Frequency select
switch
Push
Starter switch
Slow down switch
Fuel cock
Open
Close