Denyo GAW-185ES2, Инструкция по эксплуатации

Страница: 15 / 49

Periodic inspection and maintenance GAW-185ES2
- 29 -
2-2 Precautions for installation of the machine
DANGER
: Poisoning caused by exhaust gas
•
The exhaust gas from the engine contains substances that are
hazardous to human bodies.
Do not run the machine in a place of inferior ventilation such as tunnel
and indoors.
If it is necessary to run the machine in such a place, provide sufficient
ventilation using ventilating equipment or the like.
Furthermore, never direct the exhaust to passers, private homes and
others.
Serious injury or death may arise due to oxygen deficiency or toxic
gas, if the above precautions are neglected.
Select a place that satisfies the following conditions for installation of the machine.
(a) Select a level place. If the machine is used on a slope under unavoidable circumstances, the
allowable inclination angle is ±5
°
in both of longitudinal and lateral directions. Apply
appropriate slip stoppers. Fit wheel stoppers, if the machine is equipped with wheels.
[Caution]: If inflammable substances (such as paper dust and wood chips) and/or dangerous
substances (such as oil and Output name powder) are found in the vicinity, remove them before
starting welding work.
[Caution]: Provide protection screens or the like around the place of welding work, for preventing
scattering of arc light and spatter.
(b) Avoid a place of high temperature and high humidity.
(c) Avoid a place of ambient temperature over 40
°
C.
(d) Avoid a dusty place and place where noxious gases or explosive gases are present.
Furthermore, space the machine from inflammable goods in the surroundings.
(e) Locate the machine in a place where welding spatter and grinder (sander) sparks enter the air
inlet and outlet of the machine.
(f) This machine cannot be piled in tiers, as it is equipped with wheels.
(g) Never run this machine while the vehicle, on which this machine is located, is traveling or while
the machine is suspended in the air.
(h) For the bonnet air intake, provide a space of at least 50 cm from the wall face or other
obstacles.
[Caution]
: Overheat may arise, if the machine is run in a small space. If it is necessary to run the
machine under such a condition that the clearance from any side of the machine is less than 50
cm, please consult with us.
[Prohibited matters]
(1) No connection to indoor wiring
•
Never connect the AC power supply of the machine to any
indoor wiring.
•
Connection to indoor wiring violates a law, and in addition,
may cause damage to both of the indoor wiring and the
machine.
(2) No use in the rain
•
Failure may arise due to wetting of the machine and electrical
components with rainwater. Do not use the machine in the
rain.
•
Avoid water washing of the machine interior because of the
same reason.