58
ENGLISH
Playback
1
Switch
ZONE SELECT
to
“ZONE2” or “ZONE3”.
The remote control unit switches to the
operating mode for ZONE2 or ZONE3.
Input source
select buttons
2
Press
AMP
.
3
Press
ZONE/DEVICE ON
to turn
on the ZONE2 or ZONE3 power.
The
or
indicator on the
display lights.
• Also press input source select button when
in standby mode, the power turns on.
• When
ZONE/DEVICE OFF
is pressed,
ZONE2 or ZONE3 turns off.
• Power in ZONE2 or ZONE3 can be turned
on or off by pressing
ZONE2 ON/OFF
or
ZONE3 ON/OFF
on the main unit.
4
Press the input source select button.
The audio signal of the selected source is output to ZONE2 or
ZONE3.
• Turn
SOURCE SELECT
after
pressing
ZONE2/3 / REC SELECT
on the main unit to select an
input source.
When power for both MAIN ZONE and ZONE2 is set to ON, power of
the MAIN ZONE only can be turned off. Select “MAIN” in step 1 then
press
ZONE/DEVICE OFF
.
Adjusting the volume
Use
VOL
df
to adjust the volume.
G
Adjustable range
H
– – –
–80dB – –40dB – 18dB
(When the “Volume Display” (
v
page 82) setting is “Relative”)
G
Adjustable range
H
0
–
41
–
99
(When the “Volume Display” (
v
page 82) setting is “Absolute”)
• At time of purchase, “Volume Limit” (
v
page 82) is set to “–10dB
(71)”.
Turn
MASTER VOLUME
after pressing
ZONE2/3 / REC SELECT
on the
main unit to adjust the sound volume.
Turning off the sound temporarily
Press
MUTE
.
The sound is reduced to the level set at “Mute Level” (
v
page 82) in
the menu.
• To cancel, either adjust the volume or press
MUTE
again.
• The setting is canceled when the zone’s power is turned off.
You can adjust the tone and volume for ZONE2 and ZONE3 in “Zone
Setup” (
v
page 81) in the menu.
Quick select function
It is also possible to save three settings for ZONE2.
n
Saving the settings
1
Set the items below to the settings
you want to save.
q
Input source (
v
page 58)
w
Volume (
v
page 58)
2
Switch
ZONE SELECT
to
“ZONE2” or “ZONE3”.
The remote control unit switches to the
operating mode for ZONE2 or ZONE3.
3
In the zone mode for which
you want to operate, press and
hold the desired
QUICK SELECT
until “Memory” appears on the
display.
The current settings will be memorized.
G
Quick select defaults
H
Input source
Volume
Z2/Z3 QUICK SELECT 1
BD
–40dB
Z2/Z3 QUICK SELECT 2
SAT/CBL
–40dB
Z2/Z3 QUICK SELECT 3
DOCK
–40dB
n
Recalling the settings
1
Switch
ZONE SELECT
to
“ZONE2” or “ZONE3”.
The remote control unit switches to the
operating mode for ZONE2 or ZONE3.
2
Press
QUICK SELECT
at which the
settings you want to call out are
saved.
Naming quick select settings
See “Quick Select Name” (
v
page 83).
