Delta VFD-M-D series, Руководство пользователя, Страница: 73 / 163

Chapter 5 Parameters
|
VFD-M-D Series
5-40 Revision Jan. 2007, MDE2, SW V1.05
3- 02
1s t S tep
Do or H igh
Sp ee d O pen
O pen Do or (RE V)
3- 06
Do or Op en
Ho ldi ng Spe ed
3-0 8
1s t Step Do or O pe n
De celera tio n Ti me
3- 07
1s t S tep Do or O pe n
Ac ce lera tion Ti me 3- 00
Do or Op en
Co up ling
Sp ee d
3 -04
Do or Op en
Fi nal Spe ed
3- 01
Do or Op en
Hi gh Spe ed
St art
3- 03
Do or Op en F ina l
Sp ee d S tart
3- 05
Do or Op en
Ho ldi ng
Sp ee d S tart
Cl ose Do or (FW D)
4- 05
Do or Clo se
Ac ce lera tion
Time 1
Do or Op en L im it
100 .0%
4- 01
Do or Clo se
Fi nal Spe ed
St art
4- 00
Do or Clo se
Hi gh Spe ed 1
4- 06
Do or Clo se
De ce lera tio n
Time 1
4- 02
Do or Clo se
Fi nal Spe ed
4- 03
Do or Clo se
Ho ldi ng Spe ed
St art
Do or Clo se Lim it
0.0 %
4- 04
Do or Clo se
Ho ldi ng Spe ed
3 - 12 Door Open Holding Torque (100.0% is drive rated current) Unit: 0.1
Settings 0.0~100.0% Factory Setting: 50.0
3 - 13 Response Time of Door Open Holding Torque Unit: 0.01
Settings 0.01~10.00sec Factory Setting: 0.20
When the door is in the open complete position, it needs holding torque to make the door be in
that position. To prevent motor overload, the holding torque should be limited (Pr.3-12).
3 - 14 Door Open Time-out Setting Unit: 0.1
Settings 0.0~180.0sec (0.0: disable) Factory Setting: 0.0
When the door open exceeds this setting, the fault code “doEr” will occur and the motor will
decelerate to stop. It needs to have door open/close command again after resetting the AC
motor drive.
Any type of voltmeter can be used. If the meter reads full scale at a voltage less than 10 volts,
the parameter 03-06 should be set using the following formula:
Pr. 03-06 = ((meter full scale voltage)/10) x 100%
For Example: When using the meter with full scale of 5 volts, adjust Pr.03-06 to 50%. If Pr.03-
05 is set to 0, then 5VDC will correspond to Maximum Output Frequency.