Delta Milwaukee PM-1738, Инструкция по эксплуатации и техническому обслуживанию

Страница: 26 / 28

ACCESSORIES AND ATTACHMENTS (Continued)
JOINTING ATTACHMENT
The j ointing attachment is used to remove
small nicks appearing on the edge of the
knife blades, or jointing the knife blades
to the correct cutting circle. This attach­
ment is used at the normal operating speed
of 4200 rpm of the cutter head.
No parts have to be removed when
mounting this attachment to the table of
the Delta planer.
No.
22-107-Jointing Attachment.
MOTOR PUllEYS
The motor pulleys available for this ma­
chine are made from fine grey iron cast­
ings. They have three (3) grooves to re­
ceive "A" section V-belts, a 1" diameter
hole for the motor shaft, and a set screw.
In addition, the motor pulleys are bal­
anced.
All motor pulleys furnished for
this machine have a 1/4 " keyway to fit
recommended motors.
No.
1604-7" Diameter pulley with three
(3) grooves for "A" section V-belts,
1 "
diameter hole for motor shaft and set
screw. For use with 1 725 rpm motors
only.
No.
22- 1 0S - 8 ifz" Diameter motor pulley
with three (3) grooves for "A" section
V-belts,
1 "
diameter hole for motor shaft
and set screw. For use with 1 425 rpm
motors only.
No.
22- 1 1 4 -3-47/64" Diameter motor pul­
ley with three (3) grooves for "A" sec­
tion V -belts, 1 " diameter hole for motor
shaft and set screw. For use with 3450
rpm motors only.
SHAVING HOOD
The shaving hood will keep the machine
and the work free and clear of chips at all
times, enabling the operator to see the
work much better. It will reduce to a mini­
mum the possibility of the operator getting
any dust particles in his eyes.
The shaving hood when in place will fit
directly over the chip breaker. It has a
standard 6 inch diameter opening at the
top where it will connect to the regular
dust collector system in the factory or lo­
cation where it will be installed.
No.
22- 1 1 S - Shaving Hood.
V� BELTS
To assure positive drive and full transmis­
sion of power, a matched set of three (3)
V-belts is used. This type of drive pre­
vents slippage and keeps the speed of the
cutter head and feed constant.
No.
49-1 75 -Matched set of 3 V-belts, 68"
outside circumference, for use with 60
cycle motors, 3 hp, 1 725 rpm.
No.
49-176 -Matched set of 3 V-belts, 7 1 "
outside circumference, for use with 25
and 50 cycle motors, 3 hp, 1 425 rpm.
Please place your order for these items with your Delta Dealer. For prices see latest price list.
24